Bosch VideoJet 8008 User Manual download pdf (Page 18)

Installation and Operating Manual | VideoJet 8008

EN | 18

Installation Bosch Security Systems | 2005-06 | V2.0

Control cabinet installation

The VideoJet 8008 is set up for installation in a 19" rack. The necessary

assembly kit is included with the unit.

Warning!

When installing in control cabinets, ensure that each unit has adequate

ventilation. The free space around the unit must be at least 5 cm on the

right and left sides and at least 10 cm at the rear.

The ambient temperature must be within the specifications for the unit in

use (see page 128), and the relative humidity may not exceed 80%.

The unit generates heat during operation. You should therefore ensure

sufficient distance from other equipment or objects that are sensitive to

heat.

When installing additional units, direct contact with the VideoJet 8008 is

permitted if the surface temperature of the adjacent units does not exceed

+40 °C.

Installing the unit

– On the left and right side of the unit, loosen the two screws

at the front and completely remove them.

– Place the two brackets from the assembly kit recesses next to the screw

holes in the housing and screw down with the four housing screws.

– Place the unit in the control cabinet and attach the bracket to the frame using

the four screws, washers and lock nuts supplied.

– Insert the connector on the mains cable supplied into the Power socket on

the rear of the unit.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 135 136

No comments

Bosch VideoJet 8008 User Manual Page 18