Bosch D9112B Installation Manual download pdf (Page 26)

D9112B | Program Entry Guide | 2.0 Area Wide Parameters EN | 26

Bosch Security Systems | 2/04 | 74-06145-000-D

A# Delay Res

Default: No

Selection: Yes or No

Yes

Restoral

report is delayed until the

area bell time expires, and the point

returns to normal.

Restoral

reports are sent when point

restores, regardless of bell time.

A# Exit Tone

Default: Yes

Selection: Yes or No

Sound an exit tone during exit delay at command

centers assigned to this area.

A# Exit Dly Time

Default: 60

Selection: 0 to 600

Exit delay time for this area. Select an entry that is a

five sec. increment.

Points programmed for “instant” alarms generate

alarms immediately. Even during exit delay.

Note:

Fail to Close reports require exit delay time: If Fail

To Close in Opening and Closing is programmed

YES, you must enter an exit delay time.

A# Auto Watch

Default: No

Selection: Yes or No

Yes When disarmed, this area automatically goes into watch mode regardless of the status of Watch

Mode before the area is armed.

Automatic Watch does not affect manual Watch Mode toggle. You can still control Watch Mode

using Command 6.

No Watch Mode status is maintained between arm/disarm cycles. If the Watch Mode was ON at the

time the area was armed, it will be ON again when the area is disarmed. If the Watch Mode was

OFF at the time the area is disarmed, it will be OFF when the area is disarmed.

Note:

Watch Mode does not work while the area is perimeter armed.

A# Verify Time

Default: 60

Selection: 10 to 60 sec.

Alarm Verification is designed for use with smoke

detectors to reduce the number of false fire alarms.

When

Verify Time

is programmed, the panel can

double check smoke detector point activations

before generating alarm signals.

Note:

Check with your Authority Having Jurisdiction (AHJ)

to determine the maximum verification time allowed.

Points are programmed individually to activate the

verification feature. See Point Index. Any resettable

fire point can activate alarm verification for the area

to which it is assigned. Bosch Security Systems

recommends the use of separate area alarm-

verification relays.

To enable alarm verification on a point, program

Point Index

Fire Point

Alarm Verify

, and

Resettable

as Yes.

When an alarm verification point trips, the D9112

automatically removes power to all resettable points

connected to the areas

Reset Sensors

relay. The

sensor reset removes power to the sensors for the

amount of time programmed in

Verify Time

. When

power is reapplied, a 60 sec. confirmation window

begins. If the detector is still in alarm, or trips again

during the confirmation window, or if a different

resettable verification point in the area trips, an

alarm is generated.

Example 1:

Verify Time

is set for 20 seconds. The alarm

verification cycle starts when the detector trips. No

report is generated.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 95 96

Comments to this Manuals

No comments

Bosch D9112B Installation Manual Page 26

Comments to this Manuals

Related products and manuals for Security access control systems Bosch D9112B