Bosch D9112B Installation Manual download pdf (Page 51)

D9112B | Program Entry Guide | 3.0 User Interface EN | 51

Bosch Security Systems | 2/04 | 74-06145-000-D

L## Perim Inst

Perimeter Instant Arm

Default: See Training Sheet

Selection: Blank or E

Blank

Disable this function for Authority Level (L##) specified, if this Command Center Function item

requires a passcode (P).

Enable this function for Authority Level specified. When the passcode is entered at the command

center, the panel checks the authority level. The panel executes the function only in areas where the

passcode is authorized.

Programming in O/C Options Perimeter O/C determines whether Perimeter Closing reports can be

generated for a particular area.

Whether Perimeter Closing reports and subsequent Opening reports are generated by this user or

not depends on the L## Perimeter O/C prompt in Authority Lvl Assign.

Perim Delay

Perimeter Delay Arm [COMMAND] [3]:

This command center function arms all perimeter points (see Point Index

Point Type

) in the area where the

command center is assigned. No entry or exit delays are provided with this arming function.

Default: Blank

Selection: Blank, E, or P

Blank Disable the function panel-wide. Accessing the function using a command, the Command Menu, or

a custom function, displays NO AUTHORITY.

E Enable the function panel-wide. The function can be executed without entering a passcode.

Programming in O/C Options

Perimeter O/C

determines whether

Perimeter

Closing

reports can

be generated for a particular area.

P Passcode required. When the passcode is entered at the command center, the panel checks the

authority level. The panel only arms the area if the passcode is authorized.

0101

Force Arming: If a passcode is not required to arm this function, all authority levels can force arm. To

disable force arming in an area, enter 0 in FA Bypass Max in the Area Parameters section of the program.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 95 96

No comments

Bosch D9112B Installation Manual Page 51