Bosch NEI-Series User Manual download pdf (Page 25)

Dinion IP Infrared Imager Installation | en 25

Bosch Security Systems, Inc. User Manual F.01U.263.416 | 3.1 | 2012.09

pinched (about 5 mm (0.2 in.) of insulation). See

Figure 4.3, Page 27, above, for the connector locations.

4. Loosen the screws of the supplied 2-pole connector (2-pin

Power Plug) and attach the incoming power wires.

5. Attach the supplied 7-pin relay output plug to the incoming

relay wires.

6. Tighten the screws and insert the 2-pole connector into

the power socket of the camera.

7. Connect the incoming Ethernet cable to the RJ45

connector supplied in the camera junction box.

NOTICE!

For a DC supply, the polarity is important. Incorrect polarity

does not damage the camera, but will not allow the camera to

switch on. If input voltage is not within the specified range or

has incorrect polarity (DC only), the voltage indicator (a yellow

LED in the front window) turns on to indicate this condition.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 123 124

No comments

Bosch NEI-Series User Manual Page 25