Bosch NEI-Series User Manual download pdf (Page 89)

Dinion IP Infrared Imager Configuration via IP, Advanced Mode | en 89

Bosch Security Systems, Inc. User Manual F.01U.263.416 | 3.1 | 2012.09

You can activate and configure encryption of the media data

(video and metadata) on the Encryption page (see

Section 9.7.5 Encryption, page 95).

RCP+ port 1756

To exchange connection data, you can activate the unsecured

RCP+ port 1756. If you want connection data to be transmitted

only when encrypted, select the Off option to deactivate the

port.

Telnet support

If you want to allow only secure connections with encrypted

data transmission, you must select the Off option to deactivate

Telnet support. The unit will then no longer be accessible using

the Telnet protocol.

Interface mode ETH

If necessary, select the Ethernet link type for the ETH interface.

Depending on the unit connected, it may be necessary to select

a special operation type.

Network MSS (Byte)

You can set the maximum segment size for the IP packet's user

data. This gives you the option to adjust the size of the data

packets to the network environment and to optimize data

transmission. Please comply with the MTU value of 1,514 bytes

in UDP mode.

iSCSI MSS (Byte)

You can specify a higher MSS value for a connection to the

iSCSI system than for the other data traffic via the network. The

potential value depends on the network structure. A higher

value is only useful if the iSCSI system is located in the same

subnet as the camera.

NOTICE!

If you want to allow only secure connections with SSL

encryption, you must select the Off option for each of the

parameters HTTP browser port, RCP+ port 1756 and Telnet

support. This deactivates all unsecured connections.

Connections will then be possible via the HTTPS port only.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 123 124

No comments

Bosch NEI-Series User Manual Page 89