Bosch NEI-Series User Manual download pdf (Page 8)

8 en | Safety Dinion IP Infrared Imager

F.01U.263.416 | 3.1 | 2012.09 User Manual Bosch Security Systems, Inc.

4. Protect the power cord from being walked on or pinched

particularly at plugs, convenience receptacles, and the

power where they exit from the apparatus.

5. Use only attachments/accessories specified by the

manufacturer.

6. Refer all servicing to qualified service personnel. Servicing

is required when the apparatus has been damaged in a

way, such as power-supply cord or plug is damaged, liquid

has been spilled or objects have fallen into the apparatus,

does not operate normally, or has dropped. When

servicing, power shall be disconnected.

1.3 Important notices

All-pole power switch - Incorporate an all-pole power switch,

with a contact separation of at least 3 mm in each pole, into the

electrical installation of the building. If it is needed to open the

housing for servicing and/or other activities, use this all-pole

switch as the main disconnect device for switching off the

voltage to the unit.

Camera signal - Protect the cable with a primary protector if

the camera signal is beyond 140 feet, in accordance with

NEC800 (CEC Section 60).

Accessories - Do not place this unit on an

unstable stand, tripod, bracket, or mount. The

unit may fall, causing serious injury and/or

serious damage to the unit. Use only with the

cart, stand, tripod, bracket, or table specified by

the manufacturer. When a cart is used, use

caution and care when moving the cart/

apparatus combination to avoid injury from tip-

over. Quick stops, excessive force, or uneven

surfaces may cause the cart/unit combination to

overturn. Mount the unit per the manufacturer's

instructions.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 123 124

No comments

Bosch NEI-Series User Manual Page 8