Bosch NEI-Series User Manual download pdf (Page 75)

Dinion IP Infrared Imager Configuration via IP, Advanced Mode | en 75

Bosch Security Systems, Inc. User Manual F.01U.263.416 | 3.1 | 2012.09

Specify the numbers of the IP addresses to be contacted in the

event of an alarm. The unit contacts the remote stations one

after the other in the numbered sequence until a connection is

made.

Destination IP address

For each number, enter the corresponding IP address for the

desired remote station.

Destination password

If the remote station is password protected, enter the

password here.

In this page, you can save a maximum of ten destination IP

addresses and hence up to ten passwords for connecting to

remote stations. If connections to more than ten remote

stations are to be possible, for example when initiating

connections via higher-ranking systems such as VIDOS or Bosch

Video Management System, you can store a general password

here. The camera can use this general password to connect to

all remote stations protected with the same password. In this

case, proceed as follows:

1. Select 10 from the Number of destination IP address list

field.

2. Enter the address 0.0.0.0 in the Destination IP address

field.

3. Enter your chosen password in the Destination password

field.

4. Define this password as the user password for all remote

stations to which a connection is to be possible.

Video transmission

NOTICE!

If you enter the destination IP address 0.0.0.0 for destination

10, this address will no longer be used for the tenth attempt at

automatic connection in the event of an alarm. The parameter is

then used only to save the general password.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 123 124

No comments

Bosch NEI-Series User Manual Page 75