Bosch DS7447 User's Guide download pdf (Page 10)

– 10 –

Day to Day Operations

Standard Operations

This section describes the standard (those built and programmed into your system at the factory) procedures for arming and disarming

your security system. Your installing conpany can program your system for various optional operations (see also, Optional Operations).

Normal Arming

Used when no one is left on the premises, all zones are to be armed, and an entry/exit delay is in effect. The green Status LED must be lit and,

if using a DS7447/DS7447E keypad, “Ready to Arm” must be displayed. If the green LED is not on or the keypad displays “Not Ready,” see

Force Arming or Zone Bypass in Optional Procedures for other ways to arm the system.

Note: In commercial burglar alarm applications for UL Listed systems, a ring-back indication and bell test

should be heard after arming (closing). If not heard, call for service.

* DS7447/DS7447E only

** DS7445/DS7445i only

Equipment

Used

Command

Sequence

What Will

Happen

What

To Do

DS7447/

DS7447E

DS7445/

DS7445i

[PIN] + [On]

• The red Armed LED will flash.

• “Armed” will be displayed. *

• “Exit Now” will be displayed

during the exit-delay period. *

• A single beep will sound.

• The red Armed LED will turn on

steady when the exit-delay

period ends.

• All zones will arm.

RF3341

PIN] + [#] + [1]

• The LED will flash indicating a

signal has been sent to your

security system.

• All zones will arm.

RF3332

RF3334

Press ARM button All zones will arm.

Exit during the exit-delay period.

RF3502 Not Applicable

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

Comments to this Manuals

No comments

Bosch DS7447 User's Guide Page 10

Comments to this Manuals

Related products and manuals for Security access control systems Bosch DS7447