– 13 –
Standard Operations (continued)
Day to Day Operations (continued)
Custom Arming
Used to alarm zones that you specify and your installer programs into your system. An entry/exit delay will be in effect unless otherwise
programmed. The green Status LED must be lit and, if using a DS7447/DS7447E keypad, “Ready to Arm” must be displayed. If the green
LED is not on or the keypad displays “Not Ready,” see Force Arming or Zone Bypass in Optional Procedures for other ways to arm the
system.
Note: In commercial burglar alarm applications for UL Listed systems, a ring-back indication and
bell test should be heard after arming (closing). If not heard, call for service.
Used
Sequence
Happen
To Do
DS7447/
DS7447E
DS7445/
DS7445i
•
The red Armed LED will flash.
•
“On Partial” will be displayed. *
•
“Exit Now” will be displayed during the exit-delay period. *
•
The green Status LED will turn on steady.
•
A single beep will sound.
•
The red Armed LED will turn on steady when the exit-delay period
ends.
•
The zones that have been programmed for custom arming will arm.
RF3341
[PIN] + [#] + [4]
•
The LED will flash indicating a signal has been sent to your
security system.
•
The zones that have been programmed for custom arming will arm.
Exit during the exit-delay
period.
RF3332
RF3334
RF3502
Not Applicable
* DS7447/DS7447E only
** DS7445/DS7445i only
Comments to this Manuals