Bosch DS7447 User's Guide download pdf (Page 27)

– 27 –

Emergency Procedures

Identifying Alarm Sounds

Your alarm system may be programmed for a steady alarm sound or

a pulsed alarm sound. It is important to learn the difference between

a fire alarm sound and an intrusion alarm sound before you are

confronted with an actual emergency.

Silencing Alarms

All alarms can be silenced with any PIN that has disarm privileges.

Entering your [PIN] + [Off] (or [PIN] + [#] from an RF3341 keypad) will

silence the alarm and turn off (disarm) the control.

A Cautionary Note

How you respond to an alarm will depend, mostly, on the type and

time of the alarm. You should seek the advice of your installing

company as they install your system, not later (i.e. after an alarm) to

develop a response plan.

Above all else, common sense should prevail.

If there is any threat or hint of danger to yourself or others on the

premises, such as in the event of a fire alarm, everyone should be

instructed to leave the premises immediately. Do not enter the

premises unless accompanied by the appropriate Emergency

Services' personnel, or after they have given the OK to enter.

Caution When Entering A Building

An alarm has occurred if:

• The bells and sirens are on, and/or

• The red Armed LED is flashing with the DS7447/DS7447E

display reading “Zone Alarm”

• The DS7445/DS7445i zone LEDs 1-8 are flashing.

The wired keypad will also issue a pulsed tone during the entry delay

instead of the usual steady tone.

The RF3341 Keypads will not indicate that an alarm is

occurring or has occurred. With these keypads, you must

rely on signals from other devices in the system to notify

you of an alarm.

If the alarm has not been previously investigated, do not enter the

building unless accompanied by the appropriate Emergency

Services’ personnel.

Fire Alarms

Fire Alarms are silenced using the same procedure as intrusion alarms:

a [PIN] (with disarm privileges) + the [Off] key.

The Fire Alarm system is not reset until alarms at smoke detectors

are cleared by using the [System Reset] command.

The Fire Alarm system will not be functional until this procedure has

been followed. See Fire Reset.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 59 60

Comments to this Manuals

No comments

Bosch DS7447 User's Guide Page 27

Comments to this Manuals

Related products and manuals for Security access control systems Bosch DS7447