Bosch DS7447 User's Guide download pdf (Page 25)

– 25 –

Optional Operations (continued)

Day to Day Operations (continued)

Changing the Date

The System Date can only be changed in Master Programming Mode, so it is not programmable from an RF (wireless) keypad.

Note: You should write down your entries before you enter the Master Programming Mode and have them with you as you begin programming.

Make your entries promptly. If a delay of 15 seconds or more occurs between your entries, the 3-beep error tone occurs and exits you

from the programming mode.

Note: Entering the command sequence [Master Code] [#] [0] [2] [#] will cause the DS7447/DS7447E keypad to read back the date.

It is recommended that this procedure be performed at a DS7447/DS7447E keypad. No visual clues will be given from a

DS7445/DS7445i keypad.

Steps to Change the Date Command Sequence If Accepted, DS7447/DS7447E Display

Reads:

Enter Master Programming Mode. [Master PIN] + [#] [0] “2 Change Date”

(display will scroll to this)

Enter a 2 for System Date Setup

programming

[2] “Enter Month”

(01 … 12)

Enter the Month. [0] [1] through [1] [2]

January December

“Enter Day”

(01 … 31)

Enter the Day. [0] [1] through [3] [1] “Enter Year”

(XX) End with #

Enter the Year. Last two digits of the year followed by [#]. “Month, Day, Year”

A long beep signifies acceptance.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 59 60

No comments

Bosch DS7447 User's Guide Page 25