Bosch D9112B Installation Manual download pdf (Page 81)

D9112B | Program Entry Guide | 8.0 Point Assignments EN | 81

Bosch Security Systems | 2/04 | 74-06145-000-D

Point Text

Default: Command 9

Selection: Up to 16 characters alphanumeric

Enter alphabetic characters A to Z

in capital letters

Note:

Period (.), comma (,), percent (%), parenthesis [()],

equal (=), greater/less than (< >), exclamation (!),

and colon (:) are not allowed.

Enter up to 16 characters of text to describe the

Command 9 function. This point text is displayed at

command centers (if the point is programmed as

“visible”) and reported to the D6500 when

transmitting in Modem II ( if it is a reporting point).

8.3 Command 7

The Command 7 section defines how the Command 7

function operates. Program this section if

User Cmd

is enabled in the User Interface module.

This function generates an

Alarm

report from the

area where the command center is assigned. A new

report is generated each time it is activated, but only

one alarm appears in the alarm memory count at the

local area command centers. If this function is

activated in more than one area within the scope of

the command center, the alarm memory count is

increased.

Point Index

Default: 4

Selection: Blank or 00 to 31

Enter the

Point Index

code used with Command 7.

0101

Point Index 00 (or blank) only works with

Command 7 and Command 9. It is a silent,

invisible, reporting point. Point Index 00

disables a normal point.

0101

Do NOT use a point index with Resettable

programmed YES.

Do NOT use a point index with Swinger

Bypass programmed YES.

BFSK Code

Default: 7

Selection: Blank or 0 to 9

Use this entry to determine the point number

reported in BFSK when this point is tripped.

Normally, you only use this item when transmitting

reports to the central station in BFSK format.

Command centers and local printers display the

actual point number (1 to 135) not the BFSK report

code.

Activating Relays: To activate a relay on the

D8129 OctoRelay or C8137 Transmitter Interface,

see Relays

A# Command 7

Point Text

Default: Command 7

Selection: Enter alphabetic characters A to Z

in capital letters

Note:

Period (.), comma (,), percent (%), parenthesis [()],

equal (=), greater/less than (< >), exclamation (!),

and colon (:) are not allowed.

Enter up to sixteen characters of text to describe the

Command 7 function. This point text is displayed at

command centers (if the point is programmed as

“visible”) and reported to the D6500 when

transmitting in Modem II ( if it is a reporting point).

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 95 96

Comments to this Manuals

No comments

Bosch D9112B Installation Manual Page 81

Comments to this Manuals

Related products and manuals for Security access control systems Bosch D9112B