Bosch D9112B Installation Manual download pdf (Page 48)

D9112B | Program Entry Guide | 3.0 User Interface EN | 48

Bosch Security Systems | 2/04 | 74-06145-000-D

Master Arm

There are three arming functions enabled by this prompt:

• Master Arm All Areas: Arms all areas according to the

Scope

of the command center where the function is

entered (see Cmd Cntr Assignment).

• Master Arm an Area: Allows the user to select a single area to arm.

• Command 1: Local area arming; only arms the area where the command center is assigned.

How command center Scope affects area execution:

An Area Command Center can execute this function only in the area where the command center is

assigned. An Account Command Center can execute this function in all areas in the account where the

user has authority. A Panel-Wide Command Center can execute this function in all areas in the panel

where the user has authority.

Default: P

Selection: Blank, E, or P

Blank Disable the function panel-wide. Attempting to access the function displays NO AUTHORITY.

E Enable this function panel-wide. The function can be executed from any area within the command

center’s Scope without entering a passcode.

Programming in O/C Options Area O/C and Restricted O/C determines whether

Opening

and

Closing

reports can be generated for a particular area.

P Passcode required. When the passcode is entered at the command center, the panel checks the

authority level.

The panel only arms areas where the passcode is authorized that are within the Scope of the

command center. The command center display shows the areas it is arming.

0101

Force Arming: If a passcode is not required to arm these functions, all authority levels can force arm. To

disable force arming in an area, enter 0 in FA Bypass Max in the Area Parameters section of the program.

L## Master Arm

Default: See

Program Record Sheet

Selection: Blank or E

Blank Disable this function for Authority Level (L##) specified, if this item in Command Center Function

requires a passcode (P).

E Enable this function for Authority Level specified. When the passcode is entered at the command

center, the panel checks the authority level. The panel executes the function only in areas where the

passcode is authorized.

Programming in O/C Options

Area O/C

and

Restricted O/C

determines whether

Opening

and

Closing

reports can be generated for a particular area.

Whether

Opening

and

Closing

reports are generated by this user or not depends on the

L##

Area O/C

and

L## Restricted O/C

prompts in Authority Lvl Assign.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 95 96

Comments to this Manuals

No comments

Bosch D9112B Installation Manual Page 48

Comments to this Manuals

Related products and manuals for Security access control systems Bosch D9112B