Bosch D9112B Installation Manual download pdf (Page 77)

D9112B | Program Entry Guide | 7.0 Point Index EN | 77

Bosch Security Systems | 2/04 | 74-06145-000-D

P## Bypassable

Bypass and force arm the point. Points can be bypassed by entering the Bypass a Point function at a command

center, a RAM II command, or a “Bypass a Point” SKED.

To automatically return a bypassed point to the system when disarming, program

Returnable

YES. Otherwise,

you can use Unbypass a Point (Command 00), RAM II UNBYPASS command, or “Unbypass a Point” SKED.

When a controlled point is force armed, it can return to the system when the fault clears if

Returnable

programmed YES. If it is not returnable, the point stays out of the system until the area is disarmed.

If the panel is reset while a point is bypassed, a

Restoral

report is not sent when the point is unbypassed and it

returns to normal.

Default: No

Selection: Yes or No

Yes This point can be bypassed and force armed.

Note:

24-hour points can be bypassable, but the application should be carefully considered.

Buz on Fault

and

Report Bypass at Occurrence

should be YES for bypassable 24-hour points.

When a 24-hour point is bypassed, the report should be sent as it occurs. If the area does not send a

Closing report, a Deferred Bypass report is not sent.

Instead of programming a bypassable 24-hour point, consider a bypassable perimeter point type with a

Point Response

of 9 to D. 24-hour points do not show faults or bypasses when an arming command is

entered, but perimeter points do.

No This point cannot be bypassed or force armed from the command center or RAM II. However, it

can be force armed by automatic arming at the end of the closing window (see Opening & Closing

Auto Close

) or by a Sked programmed to arm the area.

P## Swinger Bypass

Automatically bypass a point if it generates four

alarms or four troubles during one clock hour (for

example, between 2:00 and 2:59). If the point has a

partial count (less than four events during an hour),

the count is reset to zero on the hour.

To return a swinger bypass point to the system:

disarm the area, use the Unbypass a Point

(Command 00) function, send the RAM II unbypass

command, or execute an “Unbypass a Point” Sked.

When a point is bypassed because of a swinger

condition, a

Swinger Bypass

report is sent.

Default: No

Selection: Yes or No

Yes Enable Swinger Bypass for this point.

Disable Swinger Bypass for this point.

P## Report Bypass at Occurrence

Generate a

Command Bypass

report as soon as it is

bypassed. This option should be enabled for all

bypassable 24-hour points. You may also elect to

report bypassed 24 –hour points at the time the area

is armed. See

Defer Bypass

report.

Default: No

Selection: Yes or No

Yes

Send a

Command Bypass

report at

the time the point is bypassed.

Do not send

Command Bypass

at the

time the point is bypassed.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 95 96

Comments to this Manuals

No comments

Bosch D9112B Installation Manual Page 77

Comments to this Manuals

Related products and manuals for Security access control systems Bosch D9112B