Bosch NEI-Series User Manual download pdf (Page 30)

30 en | Manual Camera Settings Dinion IP Infrared Imager

F.01U.263.416 | 3.1 | 2012.09 User Manual Bosch Security Systems, Inc.

6 Manual Camera Settings

Most camera settings can be adjusted remotely via CTFID

software (for analog models; refer to the Configuration Tool for

Imaging Devices User Manual at www.boschsecurity.com) or via

the web browser interface (for IP models). Some settings--lens

focus, focal length, pan, tilt, LED tilt, and the width of the

illumination beam--require manual adjustment using controls at

the back of or in the front of the camera.

6.1 Adjusting Focus, Focal Length, Pan, and

Tilt

To adjust the focal length and focus, use the controls located

on the access panel at the rear of the camera housing. An

access panel also contains the camera keypad buttons that you

use to interact with the camera’s on-screen display (OSD)

menu. This menu provides advanced set-up options for getting

the best results under special circumstances.

6.1.1 Accessing the Rear Controls

1. Unscrew the four (4) captive screws (item 1 in Figure 6.1)

of the access panel on the rear of the camera housing.

Figure 6.1 Rear camera housing with access panel

2. Open the access panel. Now you can adjust the focus and

focal length (see Figure 6.2 below).

Note: Before you make any adjustments, you may need to

connect the camera to a monitor to view the changes to

the picture. See Section 5 Ethernet Connection (IP models),

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 123 124

No comments

Bosch NEI-Series User Manual Page 30