Bosch NEI-Series User Manual download pdf (Page 87)

Dinion IP Infrared Imager Configuration via IP, Advanced Mode | en 87

Bosch Security Systems, Inc. User Manual F.01U.263.416 | 3.1 | 2012.09

Trigger relay

Click the Relay button to trigger the relay manually (for

example, for testing or to operate a door opener).

9.7 Advanced Mode: Network

9.7.1 Network Access

The settings on this page are used to integrate the camera into

an existing network.

Some changes only take effect after the unit is rebooted. In this

case, the Set button changes to Set and Reboot.

1. Make the desired changes.

2. Click the Set and Reboot button. The camera is rebooted

and the changed settings are activated.

Automatic IP assignment

If a DHCP server is employed in the network for the dynamic

assignment of IP addresses, you can activate acceptance of the

camera.

Certain applications (VIDOS, Bosch Video Management System,

Archive Player, Configuration Manager) use the IP address for

the unique assignment of the unit. If you use these applications,

the DHCP server must support the fixed assignment between IP

address and MAC address, and must be appropriately set up so

that, once an IP address is assigned, it is retained each time the

system is rebooted.

IP address

Enter the desired IP address for the camera in this field. The IP

address must be valid for the network.

Subnet mask

Enter the appropriate subnet mask for the selected IP address.

CAUTION!

If you change the IP address, subnet mask or gateway address,

the camera is only available under the new addresses after the

reboot.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 123 124

No comments

Bosch NEI-Series User Manual Page 87