Bosch NEI-Series User Manual download pdf (Page 93)

Dinion IP Infrared Imager Configuration via IP, Advanced Mode | en 93

Bosch Security Systems, Inc. User Manual F.01U.263.416 | 3.1 | 2012.09

dedicated multicast address and port for each stream. You can

switch between the streams by clicking the appropriate tabs.

A special IP address (class D address) must be configured for

multicast operation in a multicast-enabled network.

The network must support group IP addresses and the Internet

Group Management Protocol (IGMP V2). The address range is

from 225.0.0.0 to 239.255.255.255.

The multicast address can be the same for multiple streams.

However, it will be necessary to use a different port in each

case so that multiple data streams are not sent simultaneously

using the same port and multicast address.

Enable

To enable simultaneous data reception on several receivers, you

need to activate the multicast function. To do this, check the

box. You can then enter the multicast address.

Multicast Address

Enter a valid multicast address for each stream to be operated

in multicast mode (duplication of the data streams in the

network).

With the setting 0.0.0.0 the encoder for the relevant stream

operates in multi-unicast mode (copying of data streams in the

unit). The camera supports multi-unicast connections for up to

five simultaneously-connected receivers.

NOTICE!

Multicast operation requires a multicast-enabled network that

uses the UDP and the Internet Group Management IGMP

protocols. Other group management protocols are not

supported. The TCP protocol does not support multicast

connections.

NOTICE!

The settings must be made individually for each stream.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 123 124

No comments

Bosch NEI-Series User Manual Page 93