Bosch D9412GV4 Installation Guide download pdf (Page 106)

106 en | Panel and Area Wide Parameters D9412GV4/D7412GV4/D7212GV4

F.01U.218.312 | 04 | 2012.03 Program Entry Guide Bosch Security Systems, Inc.

– Local alarm annunciation and event printing; no reports are sent to the central station

receiver.

– Automatic smoke detectors reset for all Fire points programmed with P## Resettable as

Yes.

– D1255 Keypad displays a sequential count and the text for the point after each point is

activated and restored.

– If enabled in Routing, Walk Start and Walk End Reports are sent to the central station

receiver at the beginning and end of the test.

L## Send Report

Send a Test Report from any keypad assigned to an area where the user has authority.

Access Control Functions

The following five functions are used to control the doors from the keypad. These features are

not available with the D7212GV4.

Use the following functions to control the doors from the keypad. Users can have authority to

access the Door Control and can use all or part of the functions within.

L## Door Control

This item only allows programming access to the following three sub-prompts. It does not

affect the user’s access to Cycle Door, Unlock Door, and Secure Door.

The following prompts are sub-functions of Door Control.

NOTICE!

A# Verify Time for Fire points that is programmed with Yes for P## Alarm Verify is ignored

during the Fire Walk Test.

Default: Authority Levels 1, 15: Enabled (E)Authority Levels 2-14: Blank (-)

Selection: - or E

Function No. Function Name Alternate Keystroke

13 Send Report [COMMAND][4][1] or [COMMAND][4][2]

NOTICE!

All doors display when this function is selected. This function does not follow the scope of the

keypad.

Default: Authority Levels 1-2, 15: Enabled (E)Authority Levels 3-14: Blank (-)

Selection: - or E

Function No. Function Name Alternate Keystroke

14 Door Control [COMMAND][4][6]

This feature is not available with the D7212GV4. Keep the default setting.

NOTICE!

Cycle Door, Unlock Door, and Secure Door cannot be accessed through the Function List.

Door Control must be added to the Function List to access the door control functions, or

COMMAND 46 can be used.

NOTICE!

Cycle Door must be enabled for all three sub-functions to operate. If Cycle Door is disabled,

all three sub-functions do not operate.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 209 210

No comments

Bosch D9412GV4 Installation Guide Page 106