Bosch D9412GV4 Installation Guide download pdf (Page 57)

D9412GV4/D7412GV4/D7212GV4 Panel and Area Wide Parameters | en 57

Bosch Security Systems, Inc. Program Entry Guide F.01U.218.312 | 04 | 2012.03

This function allows the control panel, after it verifies the RPS passcode, to provide an

additional level of security by hanging up and dialing the RPS phone number at the central

station before allowing any upload or download.

RPS Line Monitor

This program item enables a control panel that shares a phone line with an answering

machine to communicate with RPS at the central station, even though the answering machine

answers the phone. You must program Answer Armed or Answer Disarmed. The control

panel must be in the correct armed state.

Answer Armed

Set the telephone ring counter to answer when all areas are master armed. If any area in the

control panel is perimeter armed or disarmed, the Answer Disarmed ring counter is used.

Yes When the control panel hears the correct RPS passcode, it hangs up the

phone, seizes the phone line, then dials the programmed RPS phone

number (refer to Section RPS Phone #, page 58). This ensures that the

control panel only communicates with RPS units connected to the

programmed phone number.

If the call is answered manually, the call back must be initiated

manually.

No The RPS session starts immediately. No call back is required. The

control panel can engage in RPS sessions when called from any phone

number and a proper RPS passcode is identified.

NOTICE!

When using the RPS Call Back feature, be sure to program the character “C” as the last digit in

the RPS phone number when using DTMF Dialing.

Default: Yes

Selection: Yes or No

Yes Allows the control panel to communicate with RPS after the answering

machine answers the phone.

No Use No if the control panel does not share the phone line with an

answering machine.

NOTICE!

Program this item No if it causes false seizures of the phone line or if you do not use RPS. This

indicates that a device using the same frequency tone is also using the phone line to which the

control panel is connected.

NOTICE!

If RPS Call Back is programmed Yes, the control panel hangs up the phone after the RPS tone

and a proper RPS passcode is identified. It then calls the RPS phone number.

Default: 7

Selection: 0 to 15

0 No answer.

1 to 15 The control panel answers the phone after the specified number of

rings when all areas are master armed.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 209 210

Comments to this Manuals

No comments

Bosch D9412GV4 Installation Guide Page 57

Comments to this Manuals