Bosch D9412GV4 Installation Guide download pdf (Page 18)

18 en | Panel and Area Wide Parameters D9412GV4/D7412GV4/D7212GV4

F.01U.218.312 | 04 | 2012.03 Program Entry Guide Bosch Security Systems, Inc.

ModemIIIa

ACK tone from the D6500 or D6600, program extra Cs after the phone number.

The control panel waits on line for two extra seconds for each C programmed.

Enter up to 24 of the characters shown in the Phone # table to define dialing characteristics.

For SIA CP-01 Compliance

Call Waiting Disable

If the telephone system at the installation site uses the Call Waiting feature, ensure that the

primary telephone reporting number is programmed to disable Call Waiting.

If you program the primary phone number with a sequence to temporarily disable Call Waiting

(typically *70 pause, but verify with the phone service provider) followed by the phone

number, you should program the backup phone number without the Call Waiting cancel

sequence. If the subscriber cancels Call Waiting without notifying their alarm installing

company, the control panel can still send reports using the backup number.

Keypad Programming of Phone #

D1255

1. Refer to Section 3.2 Phone Parameters, page 19 to access Programming and navigate to

the PHONE NUMBERS option.

2. At the PHONE 1 - 4 prompt, enter the phone number you wish to configure and press

[ENT]. The current phone number shows.

3. Press [ENT] to change the phone number.

4. The [PREV] button acts as a [Backspace] key and the [COMMAND] key scrolls through

special characters. Press [PREV] to delete the characters of the phone number, and then

enter the new phone number. Press [COMMAND] to cycle through the special dialing

characters {*, #, C, D}, then press [NEXT] to choose a character.

5. Press [ENT] to save the phone number.

When the keypad reads PARAMETER SAVED, your selection has been configured.

D1260

1. Refer to Section 3.2 Phone Parameters, page 19 to access Keypad Programming and

navigate to the Phone Numbers option and press the corresponding softkey.

2. At the Phone (1-4) prompt, enter the phone number you wish to configure and press

[ENTER]. The current phone number shows.

3. Press the Edit softkey to change the phone number.

CAUTION!

Dialing a Call Waiting sequence on a non-Call Waiting line prevents the system from dialing the

central station receiver successfully.

NOTICE!

Example: If the central station telephone number is 555-1234, and the primary Route Group

destination is Phone 1, program Phone 2 with the following sequence: *70C5551234.

NOTICE!

If the current phone number is longer than 20 characters, use the [PREV] and [NEXT] keys to

scroll to view the additional characters.

NOTICE!

If the current phone number is longer than 20 characters, the Previous and Next softkeys

appear. Use the softkeys to scroll to view the additional characters.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 209 210

Comments to this Manuals

No comments

Bosch D9412GV4 Installation Guide Page 18

Comments to this Manuals