Bosch D9412GV4 Installation Guide Page 79

  • Download
  • Add to my manuals
  • Print
  • Page
    / 210
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 78
D9412GV4/D7412GV4/D7212GV4 Panel and Area Wide Parameters | en 79
Bosch Security Systems, Inc. Program Entry Guide F.01U.218.312 | 04 | 2012.03
Command Center
3.11.1 Keypad (Command Center) Assignment
This programming category assigns a keypad to an area and determines if the keypad is
supervised. The keypads are connected to the control panel using a two-wire serial data
interface (SDI) bus.
This bus can support up to sixteen supervised keypads, each with its own unique keypad
address (CC) and corresponding DIP switch address settings. If the keypads are not
supervised, you can install multiple keypads with the same DIP switch address setting for up
to 32 unsupervised keypads.
Enhanced keypads (D1260 Series) and standard keypads (D1255 Series) cannot share the
same SDI Address.
CC# Supervised
Supervise this SDI address and generate Trouble SDI Reports and local trouble annunciation if
a problem occurs with this keypad or the SDI bus.
Default: 1
Selection: 1 to 16 for D9412GV4 and D7412GV4
1 to 8 for D7212GV4
DIP Switch Setting
SDI Address
(CC#)
12 3 456
1ONONONONON
2 OFF ON ON ON ON
3 ON OFF ON ON ON
4OFFOFFONONON
5ONONOFFONON
6 OFF ON OFF ON ON
7ONOFFOFFONON
8 OFF OFF OFF ON ON
9ONONONOFFON
10 OFF ON ON OFF ON
11 ON OFF ON OFF ON
12 OFF OFF ON OFF ON
13 ON ON OFF OFF ON
14 OFF ON OFF OFF ON
15 ON OFF OFF OFF ON
16 OFF OFF OFF OFF ON
Enter the keypad (CC) number for the SDI address you are programming. This number
corresponds to the DIP switch address settings shown.
Switch 5: On=Encoding Tone On (default), Off=Encoding Tone Off
NOTICE!
The D1255 can be addressed as 1 through 16. The D1260 can be addressed only as 1 – 8.
Default: No
Selection: Yes or No
Yes Only one keypad can be installed for this CC SDI address.
No More than one keypad can be installed using this CC SDI address with
the same address DIP switch setting.
Page view 78
1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 209 210

Comments to this Manuals

No comments