Bosch D9412GV4 Installation Guide download pdf (Page 54)

54 en | Panel and Area Wide Parameters D9412GV4/D7412GV4/D7212GV4

F.01U.218.312 | 04 | 2012.03 Program Entry Guide Bosch Security Systems, Inc.

P## Auto Functions Event

P## RPS Event

P## Relay Event

P## Point Event

P## User Chng Evt

3.8 RPS Parameters

Use these program items to enable remote programming software (RPS) functions in the

control panel using the on-board phone connection or a Network Interface Module. Refer to

Section 3.5 SDI RPS/Enhanced Communications Configuration, page 45 for more information on

these types of remote programming.

3.8.1 Uploading and Downloading Reports

If the control panel is programmed to send reports in ModemIIIa

reporting format, when RPS

contacts the control panel and the passcode is incorrect, the control panel sends an RPS

Access Fail Report to the central station receiver. RPS Access Fail might indicate a wrong RPS

passcode when communicating with the control panel, or a valid RPS session was abnormally

terminated.

RPS ACCESS OK is sent according to phone routing when a Disconnect command is entered

from RPS to terminate the call.

When a Reset Panel is used to terminate the call, a Remote Reset Report is sent to the central

station receiver, and an RPS ACCESS OK is placed into the control panel’s event log. Reports

in the event log that were not sent before the Reset Panel are never sent to the central station

receiver.

When RPS programming changes parameters, a Parameters Changed Report is sent to the

central station receiver. If any programming changes are made, click the Reset Panel check

box and click OK.

When RPS contacts the control panel, the RPS passcode and DataLock code are verified. If

the control panel’s passcode matches and the DataLock code does not, the control panel still

generates a RPS Access OK Event; however, the session ends immediately.

To prevent the control panel from answering the telephone automatically, enter 0 in the

Answer Armed and Answer Disarmed prompts in this section.

3.8.2 Log Threshold Reports

When the event log reaches the percentage configured in Log % Full and the control panel is

properly configured, it will contact Unattended RPS over phone or network.

If communication with RPS is unsuccessful, or if not properly configured, the control panel

generates Log Threshold and Fail to Call RPS events.

Default: Yes (Printer 1 only)

Selection: Yes or No

Default: Yes (Printer 1 only)

Selection: Yes or No

Default: Yes (Printer 1 only)

Selection: Yes or No

Default: Yes (Printer 1 only)

Selection: Yes or No

Default: Yes (Printer 1 only)

Selection: Yes or No

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 209 210

Comments to this Manuals

No comments

Bosch D9412GV4 Installation Guide Page 54

Comments to this Manuals